13. Next, create the outside shape FIGURE 3-32 (Fig. 3-32). Since the dimen- sions are all at even unit inter- vals, use Grid Snap to create the rectangle. (HINT: Right- click

on the icon and check Grid Smap.) At the Status Bar, make sure that Swap and Polar are on. Use the Line command to create the rectan- gular shape starting at point 2,2 (enter absolute coordi- nates). 14. The two inside shapes are easily created using Polar Tracking in combination with Polar Snap. Access the Grid and Snap tab of the Drafting Settings dialog boy (HINT (2.2) ^ 6.0000- 5.0000