3. You have created the following design. The manufacturing department has made 3 of these parts. Each part was inspected and measurements recorded and shown in this table. Now, it is up to you to put on your inspector hat and decide if each part is a good part or a bad part. For each part place a “G" in the first column to indicate a Good feature, or a "B" for a bad one. If you listed a "B", then in the next column, place an "R" if the part can be reworked, and an "S" if the part cannot be reworked and must be scraped. [15 pts.]

Fig: 1

Fig: 2