99 62 ASSIGNMENT 2: SINK This exercise is a step-by-step walkthrough of basic commands to create a in AutoCAD should be created in FULL SCALE. Check to be sure OSNAP is complex object. Our subject is a simple 22" x 22" sink. Remember, drawings activated to ensure lines properly intersect. Activate OSNAP midpoint option. Our method will be to: Create a framework Create construction lines to mark points of reference Trim and erase construction lines to leave desired object To begin, we will create the bowl of the sink. 1. In model space, create a 22" x 22" square. -1'-10"- 1'-10"- 2. The next step is to offset each side of the box inside 2". The lines will become the edges of the sink's bowl. -2" 3. Repeat offsetting each side 2". These construction lines will mark the center points of the circles used to create curved corners. 663 64 4. Create 4" and 2" circles at the intersection of each of the last construction lines R4" R2"- 5. Using the inner most construction lines, trim circles, frame and bowl lines to match the figure below: 6. Erase the 4 inner most construction lines created earlier This completes the shell of the sink bowl 55 65 66 With shell of the sink bowl complete, the next step is to create hardware. 7. At the midpoint of the top frame edge, create a 6" vertical center line