AME 211 - Computer-Aided Drafting and Manufacturing, Spring 2024 Micro Homework 14 Problem 1 Create a ruler-based drawing of the part shown below [front and side view, Giesecke, p268]. Copy the views shown below and add the top view, add all dimensions. Divisions are either 5mm or 0.25" (check in textbook, if necessary). Submit a PDF file with an image of your drawing to D2L. Add Top Problem 1 Item Ruler-based drawing with all details Cleanness and use of construction/projection lines Line types and widths All center lines included Consistency of dimensions Total 1 Points 20 20 20 20 20 100 AME 211 - Computer-Aided Drafting and Manufacturing, Spring 2024 Grading rubric definitions Necessary number of views: Necessary number of views means choosing the views that have the fewest hidden lines and show essential contours or shapes most clearly. Adequately represent the object. Use the combination that fits best on the paper. The right and left views (top and bottom views, front and rear views) do not need to be shown both. Consistency of dimensions: Dimensions that are used to create the drawings follow the dimensions given in the figure • In terms of units (e.g., inch or millimeter). Length of the lines compared to each other. For instance, if two lines have lengths of 2 mm and 4 mm, the length of the first line should look like half of the other line. Cleanness and use of construction lines: The constructions lines are used to layout different parts of the drawing such as lines (and edges), centers, segments, and circles to ensure that (not limited to) • The lines (and edges) that are parallel or vertical stay parallel or vertical Angles between the lines stays consistent with the given drawing Arcs follow the curvature and radius of the circle that they belong to Adding dimensions properly: • Use of dimensions lines Appropriate placement of dimensions All dimensions are listed • No extra/redundant dimensions . Use of correct notation 2