Register

Homework Help Question and Answers

Submit a new Query

Recent Homework Help Question & Answers


Question 30359

posted 1 years ago

Questión 4:For a bronze alloy, the stress at which plastic deformation begins is 275 MPa and the modulus of elasticity is 115 GPa. (6 marks – 3 marks each part)
(a) What is the maximum load that may be applied to a specimen with a cross-sectional area of 325 mm without plastic deformation?
(b) If the original specimen length is 115 mm, what is the maximum length to which it may be stretched without causing plastic deformation?

View answer

Question 30358

posted 1 years ago

Suppose you want to connect a remote speaker to your stereo. It needs to be 100 inches away.You are using copper wire. What should be the diameter of the wire if the resistance of each wire must be less than 0.10 Q? (3 marks)

View answer

Question 30356

posted 1 years ago

Do research, provide and explain two advantages and two disadvantages of using composite materials with examples. Make sure to provide references and each point should not be more than 2 lines. (4 marks)

View answer

Question 30357

posted 1 years ago

Draw stress- strain curve by hand and clearly show the following points on your curve. (2marks)
4. Uniform elastic deformation region
2. Yield strength point
3. Young's modulus (Modulus of elasticity)
1. Ultimate tensile strength

View answer

Question 21688

posted 1 years ago

16-74. The epicyclic gear train consists of the sun gear A which is in mesh with the planet gear B. This gear has an inner hub C which is fixed to B and in mesh with the fixed ring gear R. If the connecting link DE pinned to B and C is rotating at wnE = 18 rad/s about the pin at E, determine the angular velocities of the planet and sun gears.

View answer

Question 21691

posted 1 years ago

16-109. Member AB has the angular motions shown.Determine the angular velocity and angular acceleration of members CB and DC.

View answer

Question 21690

posted 1 years ago

16-107. At a given instant the roller A on the bar has the velocity and acceleration shown. Determine the velocity and acceleration of the roller B, and the bar's angular velocity and angular acceleration at this instant.

View answer

Question 21689

posted 1 years ago

*16-88. If bar AB has an angular velocity w AB = 6rad/s determine the velocity of the slider block C at the instant shown.

View answer

Question 21685

posted 1 years ago

16-57. At the instant shown the boomerang has an angular velocity o = 4 rad/s, and its mass center G has a velocity vG = 6 in./s. Determine the velocity of point B at this instant.

View answer

Question 21686

posted 1 years ago

16-67. Determine the velocity of point A on the rim of the gear at the instant shown.

View answer

Questions not Found

Most popular subject

Thermodynamics

Essay/Summary

Mechanics

Complex Analysis

Engineering Economics

Calculus

Modern Physics

General Chemistry

Strength Of Materials

Fluid Mechanics

x