Engineering Analysis with SolidWorks Simulation 2023, by Paul Kurowski Ch3 - Static Analysis of an L-Bracket: a. Follow the procedure in the book to analyze the bracket. The corresponding part (SolidWorks file) is posted on Blackboard. b. After you finished Ch 3 and obtained the requested results, perform sensitivity analysis on Max Von-Mises stress by varying the fillet radius from 0 mm (Sharp Edge) to 15 mm. In this study, you should not change the mesh settings. c. Calculate and compare the stress concentration factors for part b. d. Using probe command, plot and compare (along 20mm width) the value of Von- Mises stress for Sharp Edge and 15mm fillet radius.

Fig: 1