Problem 3 Create a ruler-based drawing of the part shown below [Bethune - Engineering Graphics with AutoCAD 2020, p511], with front, top and right side view, including dimensions. Use section views where appropriate. Dimensions are given in millimeters. Add the dimensions, tolerances and specifications shown below to the drawing. Scan or take a picture of your work, combine pictures of first and third problems into a single PDF and submit to D2L. A. Hole 1 is datum A. B. Hole 2 is to have its circular centerline parallel to datum A within 0.2mm at MMC when datum A is at MMC. C. Assign a positional tolerance of 0.01 to each hole's centerline at MMC. 30 -R 20±0.07 BOTH ENDS 10.00 9.95 2 HOLES FRONT

Solved: Problem 3 Create a ruler-based drawing of the part shown below [Bethun

Home
questions and answers
problem 3 create a ruler based drawing of the part shown below bethune

Question

Problem 3 Create a ruler-based drawing of the part shown below [Bethune - Engineering Graphics with AutoCAD 2020, p511], with front, top and right side view, including dimensions. Use section views where appropriate. Dimensions are given in millimeters. Add the dimensions, tolerances and specifications shown below to t