Topic: Effect of vehicle types on gap acceptance at major/minor T-junctions You need to write 10 pages Literature, a, including figures, tables, charts, graphs, equations... when needed Please include - gap

acceptance and what it is, lag and lead, critical gap, headway... etc as student needs to refer to them in the other sections of his dissertation Follow the instructions attached. Put graphs, images and equations as mentioned in the example file/n - + * Search Typographical Design and Word Count (cont.) • The document must be written concisely, in good quality technical English and spell-checked in UK English. Paper format must be A4 printed single-sided (be aware that many systems default to LETTER size paper when printing). The margins must be 30mm left, others no less than 25mm. The font must be 12 point Times New Roman in 1.5 line spacing (except the Abstract should be in 1.0 line spacing). Each page must include the page number in the footer. The document must be left justified (including figures and tables). Lines should not be inserted between paragraphs but Paragraph Formatting must be set to 6pt after to produce a separation between paragraphs. 41 The text must be written with consistency - the same expression appears in the same form throughout the document. 42 Typographical Design and Word Count (cont.) ● + ** Typographical Design and Word Count BEng submissions should be limited to 10,000 words. MEng submissions should be limited to 9,000 words at Part 1, and 12,000 words at Part 2. Q Search 37 Though these word counts are guides and a tolerance of 10% is admissible, submissions which exceed 125 sheets may be rejected before marking. It is therefore important that students write concisely and understand that a well written text will have been edited and rewritten several times before being ready for submission. 38 W ● + appears in the same form throughout the document. Q Search Typographical Design and Word Count (cont.) No more than three levels of heading may be used (as shown): 4.0 Introduction 4.1 Data collection methods 4.1.1 Requirement of the method Illustrations must be professionally drawn, low quality figures will be penalised. Lettering within illustrations should be large enough that the smallest elements will still be clear and legible. Titles should be provided at the bottom of the Figure. If a Figure is extracted from another source, the source should be indicated at the foot of the Figure and included in the Reference List. 43 Tunographical Docian and Word Count 65 42 It is the time period of travel. Example of a Table Tables must be clear and legible with the title at the top of the Table. If a Table is extracted from another source, the source should be indicated at the foot of the Table and included in the Reference List. Search Table 3.11 Typical tests and properties to be monitored for highway maintenance. Property Method Longitudinal Profile / Ride Quality HRM/RSS Rut Depth HRM/RSS Transverse Profile Skid Resistance Macro-Texture HRM/RSS Structural Strength / Residual Life Deflectograph Visuals RSS SCRIM Falling Weight Deflectometer Manual (Paper of DCD) Vehicle based (DCD or Video) Referencing and Citation It is now Ilaivorcit malinu that all referencing and citation in in ZA 46 ww 47 W - Q Search + Figure 4.3 Typical speed distributions from traffic field surveys Example of an Equation Equations must be clear, legible, numbered within each chapter and all variables must be defined. Example: x = ut + 1 gt² 2 where, x is the distance travelled, u is the initial velocity; g is acceleration due to gravity; and It is the time period of travel. —II IA B Equation 4.9 45 46 W