You in start the Pinter 3. Print the MANFCELL Drawing in Two Standard Scales A. Open the MANFCELL drawing from Chapter 9. Check to make sure that the Limits settings are at 0,0 and 40',30'. B. Activate the Layout1 tab. If a viewport exists, Erase it. Use Pagesetup to select a printer to print on a letter ("A") sheet size. Next, create a Single viewport with the Fit option on layer 0./nC. In this step you will make one print of the drawing at the largest possible size using a standard architectural scale. Use any method to set the viewport scale. Use the "Architectural Table of Limits Settings" in the chapter for guidance on an appropriate scale to set. (HINT: Look in the "A" size sheet row and find the next larger Limits settings that will accommodate your current Limits, then use the scale shown above at the top of the column.) Save the drawing. Make a print using the Plot dialog box. D. Now make a plot of the drawing using the next smaller standard architectural scale. This time determine the appropriate scale to set using either the "Architectural Table of Limits Settings" or by selecting it from the Viewport Scale pop-up list or Viewport Scale drop-down list.

Fig: 1

Fig: 2