AME 211 - Computer-Aided Drafting and Manufacturing, Spring 2024 Using rulers and compass recreate (copy) the drawing from [Technical drawing with Engineering Graphics, 16th ed] page 165, Exercise 4.39 to

a letter-sized sheet of blank paper (engineering paper or paper with any kind of markings, guides are NOT allowed). Please do not include neither dimensions nor notes. Notice how the drawing says "Metric" indicating that the numbers are in mm not inches. Please do accurate, clean work where you use the drawing construction techniques shown in the book. Keep any construction lines you used. Once complete, scan or take a picture of your work and upload the pdf/jpg to D2L. The problem is inserted below for reference: 8x Ø 12. 0122 METRIC Micro-Homework 01 Line types Center lines / lines of symmetry Consistency of dimensions Total 45°- Problem 1 Item Use of rulers and compass Cleanness and use of construction lines 4X 30° 4X67 4X 67/ 1 4X12 Ø50 4X 30° T 4X 30° 4X15 0154 Points 20 20 20 20 20 100 AME 211 - Computer-Aided Drafting and Manufacturing, Spring 2024 Grading rubric definitions Cleanness and use of construction lines: The constructions lines are used to layout different parts of the drawing such as lines (and edges), centers, segments, and circles to ensure that (not limited to) ● the lines (and edges) that are parallel or vertical stay parallel or vertical. angles between the lines stays consistent with the given drawing. arcs follow the curvature and radius of the circle that they belong to. Consistency of dimensions: Dimensions that are used to create the drawings follow the dimensions given in the figure In terms of units (e.g., inch or millimeter). Length of the lines compared to each other. For instance, if two lines have lengths of 2 mm and 4 mm, the length of line 1 should look like half of the other line. 2