Question

Hydraulics

Q1. Determine the power requirement (in hp) for a motor that is needed to drive the pump installed in a pipeline that moves 3.2 m³ /s from reservoir A to reservoir B. The 100 m long, 80 cm diameter pipe is made of rough concrete. The water surface of reservoir B is 20 m higher than the water surface of reservoir A. The overall efficiency of pump is 60%.

Verified

### Question 45163

Hydraulics

4. A closed cylindrical tank filled with water. The liquid in the top part of the piping system has a specific gravity of 0.8, and the remaining parts of the system are filled with water.
If the pressure gage reading at pointA is 60 kPa, determine the pressure inpoint B in kPa.

### Question 45162

Hydraulics

3. Bourdon gages are used to measure pressure.When such a gage is attached to a closed water tank as shown below the gage reads 5 psi. What is the absolute air pressure in the tank? Assume standard atmospheric pressure of 14.7 psi.

### Question 45161

Hydraulics

2. For the tank shown below, determine the reading of bottom pressure gage in psi if the top of the tank is sealed. The top gage reads -10.8 psi, and the depth of the oil is 6.25 ft.

### Question 44277

Hydraulics

Consider the hydraulic lift system in the figure below, with 10 mm rod and50 mm cylinder, used to lift a 500 kg load.
A hand pump is being used with a stroke of 7 cm3 per pump actuation.How many pump cycles would be required to lift the load 100 mm high?
d) Assume you operate the hand pump at a speed of 0.3 Hz. How long would it take to lift the load 100 mm high?
e) What is the work and power required from the pump operator?
f) Assume now an electric motor is being used that pump at a rate of 3litres / min. How long would it take to lift the load 100 mm?
What is the work and power required from the electric motor?

### Question 44276

Hydraulics

Explain the advantages associated with servo control using an example.

### Question 44274

Hydraulics

a) Explain briefly the different valve configurations shown. (3 marks)
b) Name three typical applications in which Tandem centre spoolconfiguration is used. (1.5 marks)
What is the chief disadvantage associated with this configuration? (1.5marks)

### Question 44273

Hydraulics

b) What is valve overlap? (2 marks)
c) Why is some amount of valve overlap desirable? (1 mark) overlap. (2marks)

### Question 44272

Hydraulics

In a direct acting pressure relief valve, 64 bar pressure is acting on the conical dart seating area and the dart is kept closed by a spring force of 50 kg opposing the pressure.
a) Determine the bore diameter on the seat.
What will the spring force be if a pressure of 3200 kPa is acting on diameter of 10 mm seating area?

### Question 44271

Hydraulics

a) Give a graphic representation of the 6 different types of pressure control valves. (4 marks)
b) The circuits below are an illustration of the working of a pressure reducing valve and a high-low system employing an unloading valve.Explain the operation of the valves. (8 marks)

### Question 44270

Hydraulics

A pump delivers 40 litres/min to a 90 mm bore/30 mm rod cylinder to lift a load of 200 kg.
a) What is the pressure exerted on the piston?
b) What is the speed at which the load will be lifted?
How much power is required to lift the load at this speed?