Reading Assignment 4.5(textbook)- Read thoroughly before you start. The scope of this project is to design a full Bridge Rectifier circuit to the following specifications: Use DIN4002 or a similar one for bridge. The diodes available must have a 0.70 V drop when conducting.Use a source voltage that results in an average output voltage of 16 V at Vout. Use a source frequency of 60 Hz.Assume that a 1 V peak to peak ripple voltage is acceptable.Must be able to provide 20 mA to load resistor R.. ANALYSIS: Calculate a)Required rms voltage that must appear at source

Fig: 1

Fig: 2

Fig: 3

Fig: 4

Fig: 5

Fig: 6