Search for question
Question

[20 mi 5. Create a voltage source labelled V3 and connect the positive terminal to a named net cal... Vin. Set a source resistance for the voltage source by right clicking

on it and entering a value into the Series Resistance box. Voltage Source - V3 DC value[V]: Series Resistance[2]: 2000 X OK Cancel Advanced Comment Figure 1: Setting the Series Resistance of V3 (for example to 2000 ohms). The value you use should be between 1000 and 10000 ohms. This setting will give the voltage source an output resistance. Looking from the point of view of an amplifer with an input of Vin, this is the also the source resistance. Design a circuit that will amplify the signal Vin with a gain of H dB. The gain of the circuit must not depend upon the value of Series Resistance chosen above. That is, if the Series Resistance is changed, the value of the output voltage should remain the same or almost identical./nThe named net for the input voltage should be Vin and named net for the output voltage must be Vout. Only use integer (whole number) values of Ohms for your resistances (round the value you require to 0 decimal places). [20 marks]

Fig: 1

Fig: 2