. A dog-bone specimen of aluminium was pressed out

Question
. A dog-bone specimen of aluminium was pressed out of 5 mm sheet. The gauge length was 65 mm with a width of 13 mm. The sample was tested in

tension, with the load elongation characteristics shown below: i.Plot the data as engineering stress versus engineering strain ii.Calculate the Young's modulus ii.Determine the yield strength t a strain offset of 0.002 iv.Determine the tensile strength of this alloy Estimate the toughness of this alloyV. b) A specimen 750 mm long is exposed to a tensile stress of 60 MPa at 925 °C, to induce a creep rate of 104 h².Determine the new length after 1000 hours assuming both the instantaneous and primary elongation is 1.5 mm.

Question image 1Question image 2Question image 3Question image 4Question image 5Question image 6Question image 7Question image 8