BF Beginner's Guide to SOLIDWORKS 2023 - Level 1 - by Author- Alejandro Reyes 1. Create the CAD Part Model & Submit Exercise 4 on Pg. 108 (Make sure Units are Set to mm) 2. Create the CAD Part Model & Submit Exercise 5 on Pg. 130 3. Create the CAD Part Model & Submit Exercise 11 on Pg. 223 20:22 20:21 Beginner's Guide to SOLIDWORKS 2023 - Level I 10 Exercise 4 DIMENSIONS: Millimeters MATERIAL: ABS 130 10 30 R5 TYP 10 20 20 160 -M6x1.0 Tapped Hole Default depth (2X) 40 R10 15 15 40 40 25 25 EXPERT TIP: • Make a single linear pattern in both directions at the same time. Under the "Direction 2" section, turn the "Pattern seed only" option ON; this way only the original feature will be copied and not create a rectangular pattern. Direction 2 Edge<2> Spacing and instances Up to reference 30.000mm Pattern seed only Features and races Beginner's Guide to SOLIDWORKS 2023-Level I Exercises: Build the following parts using the knowledge acquired so far. Try to use the most efficient method to complete each model. Exercise 5 DIMENSIONS: INCHES MATERIAL: 0.250 (12X) 04.500 0.500 (12X) 02.000 375 06.000 0-0-0-01 250 + 03.000 625 250 1.000 HINT 250 1.000 3.000 .750 T TIPS: SECTION A-A 750 1.500 250 Draw the profile and create the revolved feature. Add both holes with the same sketch; make one circular pattern. Exercises: Build the following part using the knowledge acquired in this lesson. Try to use the most efficient method to complete the model. High resolution images provided in accompanying book files Exercise 11 DIMENSIONS: INCHES MATERIAL: Chrome Stainless Steel 0.201 THRU 1/4-20 UNC THRU .850 2.500 1.250 .525 R.200 4.000 .075 X 45° 02.000 1.000 R.125 .500 SECTION A-A 06.000 03.000 1.250 6X.201 THRU ALL 1.500 0.375 .190 5.000 (Counterbore for 10-32 4.000 Socket Head Cap Screw) 223