D B A 8 7 5 4 3 200PSI NITROGEN жа 650 1SUP-1 QUICK DISCONNECT <FRL> FILTER REGULATOR LUBRICATOR 30PSI DI WATER STATE CLEVE EVELAND 1964 UNI RSITY 2SUP-1 ACTUATED VALVE EXERCISE NOTES: *NITROGEN LINE DIAMETER=0.25" *DI WATER LINE DIAMETER=0.50" *IN PORT COLORS=BLUE OR GREEN *OUT PORT COLORS=YELLOW OR ORANGE *MISSING LINES ARE: 1SUP-2,2SUP-2,1SUP-3, 2SUP-4,2SUP-6,2SUP-7,2SUP-8,2SUP-5 ELECTRO-PROPORTIONAL REGULATOR 4 1SUP-2 1 3 2SUP-2 PUMP 2 1SUP-3 <30-8000PSI) 2SUP-4 2SUP-6 66m² 2SUP- 2SUP-8 OUT REGULATOR CHECK VALVE GAGE 2SUP-3 RELIEF VALVE CLEVELAND STATE DIMENSIONS ARE IN INCHES UNIVERSITY 8 .XX = ± 0.010 .XXX = ± 0.005 .XXXX = ± 0.002 ANGLES = ±30 MINUTES 6 UNLESS OTHERWISE SPECIFIE DESCRIPTION: HW#07-PRESSURIZER HYD/PNE SCHEMATIC NAME: JOHN SMITH 5 2SUP-5 MATERIAL: N/A PRINT# HW#07SCH-01 CSUID#: 1234567 DATE: 01/17/16 4 3 2 DRAIN SCALE: N/A CLASS: TUE/THUR REV: N/A A/n CLEVELAND STATE UNIVERSITY SWEEPING: SWEEPS 1. Open the rig.sldasm file and follow the schematic.pdf to sweep the required tube sbetween parts. The diameter of the tubes is specified on the schematic. A fillet of 0.75" should be applied on every tube bend. 2. Upload the completed assembly rig as a SW Assembly file. VIRTUAL REQUIRED! Make all parts virtual (right-click each part on assembly>Make Virtual). This will remove all external references to the parts. The grading staff will assume parts with broken references as nonexistent and grade accordingly.