Fig Q3(al) is a load line diagram of the diode and resistor circuit shown schematically in Fig Q3(a2). What is the value of RL and the maximum value of Vs

of the circuit?[- Fig Q3(b) is a full wave rectification circuit. Sketch the input and output voltage waveforms (Vin and Vout) using the fact that Cs=1 µF, RL = 10KOhm, 1KHZ – AC signal and 10V peak to peak value of theVin-[7] Now replace the smoothing capacitor Cs with a value 0.01 µF and on the same figure that you made above (where you have Cs=1 µF) add a second output waveform to the sketch for this situation.[3] Explain why the output waveform has been modified as a result of changing the value of the smoothing capacitor.[2] Sketch a schematic view of a possible circuit design for single stage amplifier circuit based on a single stage field effect transistor with the following characteristics: i) Voltage gain ~ 1 ii) Large input impedance iii) Small output impedance