Question

Mastercam Portion [45pts total] Use Solidworks to create the coordinate system on the midterm part. Place the coordinate system on the face that is colored blue while ensuring the face colored red is normal to the positive Z-axis. Note, the center axis of the part should be the positive X, red face should be positive Z and Y axis should be radial. Export the file as the correct file extension and include the solidworks file. [10pts] Use the following tool parameters to make the part [20pts]. In addition make the following features only in Mastercam, create 3 slots, with the first slot being parallel to the red surface, that are equally spaced apart and is the entire length of the shaft, where the hexagon and 5 inch shaft connect. Slot dimensions are .1875 × 7 × .375 [radius × length x depth] [10pts]. Submit the Solidworks file, exported Solidworks file, and finished Mastercam file to canvas along with the PDF of the midterm. Lastly, in your own words, explain a few ways that we can create slots on the cylindrical area of the part. [5pts]/nFlat End Mill Parameters: Surface Feet per Minute (SFM): 400 Feed per Tooth (FPT): .004 in flute min Contour Parameters: - "Depth Cut" Max Rough Step Allowed: 0.185 in - "Multi Passes" Max Spacing Allowed: .2 ⚫ Pocket Parameters:/n"Roughing" Max Stepover percentage Allowed: 30% - "Depth Cut” Max Rough Step Allowed: 0.185 in Flat End Mill Parameters: Surface Feet per Minute (SFM): 400 ain Feed per Tooth (FPT): .001 - .003 in flute Contour Parameters: - "Depth Cut" Max Rough Step Allowed: 0.125 in "Multi Passes" Max Spacing Allowed: .15 Pocket Parameters: - "Roughing" Max Stepover percentage Allowed: 30% "Depth Cut" Max Rough Step Allowed: 0.125 in Flat End Mill Parameters: Surface Feet per Minute (SFM): 400 min ■ Feed per Tooth (FPT): .001.0035 in flute Contour Parameters: "Depth Cut" Max Rough Step Allowed: 0.125 in - "Multi Passes" Max Spacing Allowed: .15/n⚫ Pocket Parameters: - "Roughing" Max Stepover percentage Allowed: 30% - "Depth Cut" Max Rough Step Allowed: 0.125 in Drill Parameters Surface Feet per Minute (SFM): 300 min ⚫ Feed per Tooth (FPT): .0025 in flute ■ Max peck: 0.12 in Drill Parameters 64 MSE509 9 MIDTERM MSEM DEPARTMENT Surface Feet per Minute (SFM): 220 Feed per Tooth (FPT): .004 Max peck 0.3 in in flute min Spring 2024

Get Instant Homework HelpOn Your Mobile

Get Instant Homework HelpOn Your Mobile

Get Instant Homework HelpOn Your Mobile