/nThe special project uses the Cadence tools that you used in your Labs. In this project you will create a crossbar array of resistors driven by a simple DC volage source for input and a grounded node where the output current is measured. The current through each resistor and the voltage for each wire are measured and entered in the table for the appropriate case. Also, measure the total current to ground out Va. There are three tables for the three cases: Case 1 has all of the resistors with a low resistance value which is given in the table for Case 1. Case 2 has all of the resistors with a high resistance value which is given in the table for Case 2. Case 3 has specific resistance values for each student which needs to be recorded in the table by the student. For Memristor Project 1 use a 3x3 array of resistors as shown below. Va Gnd lout Vb measured Measured Vc M3a M3b M3c Se Maa M2b M2c មាណវ mus M1b M1c

Fig: 1