Question

Signals

X2(t) = x(3t- 6)

3) Given that x(t) has the Fourier transform X(jw), express the Fourier transforms of the signals listed below in terms of X(jw). You may find useful the Fourier transform properties listed in the attached Table

Verified

### Question 45411

Signals

Question II: Figure (2) shows the function g(t), draw the function g(-3t+4.5) showing the calculations for the points in the graph.(7.5 Marks)

### Question 45410

Signals

I: For the signal g(t) shown in figure (1) below:
a. Determine the period of the signal g(t). (1 Mar
b. Determine if g(t) represents power or energy signal and then calculate the value of it.(6.5 Morlca)

### Question 42955

Signals

Q4) A radio transmitter operated at f0 MHz has an internal impedance of ZG N and it delivers power of Pdel W to a matched load. It is connected to an antenna of impedance ZL Q via a loss-free ZO Q coaxial cable with length of L m. Find
a) The The venin equivalent of the transmitter together with the transmission line, i.e., with respect to load terminals.
b) The power delivered to the antenna.
c) The power reflected back to the generator.

### Question 42954

Signals

Q3) The results of a slotted-line experiment are plotted in the following figure. The length of the line is & cm; its characteristic impedance is Z0 Q.
d) The reflection coefficient at the generator terminals.
a) The reflection coefficient at the load.
c) The input impedance.

### Question 42953

Signals

) For the T network shown below, R1 and R2 given on the table. Find
a) The scattering matrix
b) The reflected-to-incident power ratio.
c) The transmitted-to-incident power ratio.
d) The loss-to-incident power ratio.
e) What is the function of this device?

### Question 41049

Signals

2. Consider Amplifier and filter system

### Question 41048

Signals

Problem 1. Determine the Discrete-time Fourier Transform of A squarewave is
x[n]=(0.5)^{n} u[n]
\text { Plot the magnitude and phase of } H(\Omega) \text { in matlab. }

### Question 40577

Signals

A silicon sample is in equilibrium at T = 400k. It is given that the hole concentration of po =7.1 x 1016 cm-3 at this temperature.
What is the concentration of electrons?
[10 Points] Where is the Fermi level located with respect to the intrinsic level? (A numerical answer is required)

### Question 40576

Signals

Consider a substrate of silicon at T = 300 K is doped with arsenic atoms (donors) having a concentration of 3× 1015 cm-3 and with boron atoms (acceptor) having a concentration of3 x 1014 cm-3. Consider that Np and NA are not affected by temperature.
[15 Points] At two different temperature points T = 300 K and T =700K, Is the material n- or p- type semiconductor? Justify your answer and explain the effect of the temperature on this.

### Question 40575

Signals

The energy band diagram of germanium shows the location of a particular energy levelE, at T =600 K.
[10 Points] What is the type of semiconductor represented in the energy diagram?Justify your answer.
Calculate the number of free electrons at energy level E,.
| Calculate the intrinsic carrier concentration.
| If Na is considered as zero, calculate the number of Donor atoms (ND).
Calculate the total number of free electrons.